
WARNING: When using pneumatic tools, basic
precautions should always be followed to reduce
the risk of personal injury.
WEAR EYE AND HEARING PROTECTION.
Always wear hearing and eye protection devices
when you are operating the GypFast Air, Air HD
tool or working in the vicinity of this tool. Also,
your eye protection must meet the requirement of
ANSI Standard Z87, and should have side shields
for increased protection.
CONNECTION TO THE SUPPLY OF ENERGY
Never, under any circumstances, connect the
tool to an Oxygen, Air or Gas cylinder or bottle of
any description. FAILURE TO OBSERVE THIS
IS EXTREMELY DANGEROUS AND COULD
RESULT IN A SERIOUS EXPLOSION.
Use only clean dry regulated compressed AIR
from a COMPRESSOR.
CHECK that the air pressure of the compressor
does not exceed the maximum working pressure
indicated on the tool.
FASTENERS
Only fasteners made or approved by Ramset
are to be used in this tool. Use of fasteners
not approved by Ramset may cause jamming,
serious damage to the tool, and could be
hazardous. Fasteners are steel, bugle head
collated nails in a plastic coil. The range of
nails driven are lengths of 1” (25mm), 1-1/2”
(38mm), 2” (50mm) and 2-1/2” (63mm).
SAFETY WHEN USING THE TOOL
Check before commencing to use the tool that
the safety and triggering mechanism is functioning
properly, and that all nuts and bolts are tight.
NEVER CARRY THE TOOL WITH THE TRIGGER
PULLED BECAUSE YOU MAY UNINTENTIONALLY
ACTUATE THE SAFETY SYSTEM WITH THE
RESULT THAT A FASTENER MAY BE DRIVEN
INTO YOU OR A CO-WORKER.
• DONOTuseorhandlethetoolotherthanin
themannerspecified.
•DONOTdisassembleormakeinoperative
anypartofthetool,suchasthesafetyyoke.
•DONOToperateatoolifthesafetysystem
sticks,bindsorisdisconnected,ordefective
in any way.
•DONOTmodifythistool,oruseanymodified
toolotherthanafactoryapprovedmodel.
•DONOTuseamalfunctioningtool.Ifatool
isnotoperatingproperlyhaveitrepairedby
qualifiedservicepersonnel.
•DONOTpointthetoolatyourselforanyone
else,whetheritcontainsfastenersornot.
TO PREVENT UNINTENTIONAL TOOL
OPERATION
ALWAYS DISCONNECT THE TOOL FROM THE AIR
LINE WHENEVER:
• Thetoolisleftunattended.
• Maintenanceorrepairsaretobepreformed
onthetool.
• Clearingajam.
•Movingthetooltoanotherlocation.
To avoid personal injury to yourself, or others,
obtain
training in safe tool operation, and read this
instruction
manual before using the tool.
Repairs to the tool must be performed by qualified
service personnel only. Use only Ramset authorized
parts for repair or replacement. If you have any
questions about safe tool operation, contact your
local Ramset sales person.
SAFETY PRECAUTIONS
3
SAFETY PRECAUTIONS
Komentarze do niniejszej Instrukcji