RAMSET TF1200 Instrukcje Operacyjne

RAMSET TF1200 TOOL SYSTEMOPERATOR’S SAFETY & OPERATING INSTRUCTION MANUALDANGERREAD AND OBEY ALL SAFETY AND OPERATINGINSTRUCTIONS BEFORE OPERATIN

TOOL OPERATIONAlways check the tool first to make sure that it does not contain a fastener. If the tool contains a fastener from a previous applicatio

SERVICING / TROUBLESHOOTINGSERVICING / TROUBLESHOOTING11SYMPTOM POSSIBLE PROBLEMS SERVICEPreparing Tool for Operation—Battery/Charger Problems — Ba

SYMPTOM POSSIBLE PROBLEMS SERVICEPower/Exhaust Stage of Operation — Tool operates — Battery cell is — Charge Battery Cell properly, but faste

Ramset warrants that new TF1200 Magazine systems power fastening tools, parts and accessories will be free from defects in material and workmanship

FOR TOOL REPAIR SERVICE CONTACT YOUR LOCAL AUTHORIZED RAMSET DISTRIBUTOR OR TO FIND YOUR NEAREST RAMSET TOOL REPAIR CENTER VISIT OUR WEB SITE AT WWW

SAFETY INTRODUCTION DANGERSAFETY INTRODUCTION DANGER2! Read, understand and follow the instructions in the tool manual before attempting to use

Preparation For FasteningAcceptable Base MaterialsThe gas powered TF1200 tools is suitable for use in the following base materials only:• Poured Co

FASTENING APPLICATIONSFASTENING APPLICATIONS 4FASTENING APPLICATIONSYour TF1200 tools can be used for a wide range of fastening needs in a variety of

FAILURE TO FOLLOW INSTRUCTIONS CAN CAUSE INJURY TO THE TOOL OPERATOR OR TO BYSTANDERS.• Use the tool only in well ventilated areas.• Always hold

BATTERY CELL AND CHARGER The first step in preparing a new tool for operation is to fully charge the new Battery. New Batteries are shipped discharged

INSTALLING THE BATTERY• Insert the battery into the tool as shown on the right with the clip facing out.• The battery has two positions in the

FUEL CELL AND METERING VALVEFUEL CELL AND METERING VALVE8Fuel Cell DANGER EXPLOSION/FIRE HAZARD Read ALL safety instructions before using or handling

FUEL CELL AND METERING VALVE 9FUEL CELL AND METERING VALVEINSERTING FUEL CELLWith the Metering Valve Stem pointed toward the front of t